Where to Install the Thermostat in a Two Story House

Thermostats are available in just about all newly constructed domiciles. But, in the event that you intend on creating a new house, have to replace a current thermostat, or would like to relocate a classic thermostat then you will have to look for a new spot to set up it. Determining where you can use a thermostat in a two-story house isn't a tough task. You'll just require a few tools to get going like a screwdriver, wire hanger, new thermostat, mounting screws, tape, marker, small level, pencil and perhaps an electronic camera.

Location Where to set up a thermostat in a two-story home is someplace that's readily available by every one in your home. It is easiest to put the thermostat on the floor level and this way it won't be difficult to operate wire from the basement. However, sometimes the 2nd floor could be colder or hotter with respect to the season in older houses. If this is actually the case you might want to relocate the thermostat to an upstairs bedroom or buy a thermostat with a handheld remote control to be able to increase or reduce the temperature as needed and never have to go downstairs. The fundamental rules of placing a thermostat are to put it on an inside wall that's five feet up from the ground. Yet another rule to follow along with when placing a thermostat would be to put it out of sunlight or drafty areas because those conditions could negatively affect the thermostat's temperature reading. Installing The very first thing that you ought to do when installing a thermostat in a two-story home would be to switch off the breaker switches to the furnace and the ac. If these breakers aren't switched off before you pull wires it could cause a blown fuse or may even shock you. When installing a brand new thermostat you need to run the ac and heater wires up from the basement and pull them up to and including nearby interior wall. A little hole should then be drilled so when the wires are pulled up, you are able to pull them out. When the wires are pulled out they must be labeled and wrapped around a pencil so they don't fall right back through the wall. You need to then just take the brand new thermostat and put it flush from the wall. Place an amount along with the thermostat mount to be certain that it's level and go to drill holes. When the mount is screwed in then connect the wires for their corresponding locations. Snap on the thermostat cover and turn the breakers right back on. If the thermostat can not work then you definitely probably connected the wires wrong. Flip the breakers off again and reconnect the wires before thermostat functions correctly.